In many parts of your house, the Netgear WAX615 Setup Access Point can provide a stable internet connection. You can connect it to the router in order to access the internet. This page contains all the information you need to set up the access point, update its firmware, and modify its password.
How to Set Up Netgear WAX615 Access Point?
This Netgear access point is cloud-manageable. As a result, the Insight Cloud Management website allows you to configure it. Below are the standard setup guidelines for the Netgear WAX615 access point:
- To power up your WAX615, you can connect it to a PoE switch or an electrical outlet.
- If the AP is directly attached to a wall outlet, connect it to the router using an Ethernet wire.
- Once all of the lights on the WAX615 access point are green, visit insight.netgear.com on a PC.
- Enter the password and email address associated with the Insight account.
- The location of the current network must be chosen by an experienced user.
- Select “Add Device.” Enter the AP’s serial number and MAC address. Go ahead.
- Change the name of the WAX615 access point.
- Click Next.
- Permit the successful addition of the AP to the gateway.
- The Netgear WAX615 access point has been fully configured.
Changing the Admin User Account Password for WAX615
You must input the AP admin password in order to access the local GUI. It is password-protected by default.
- On the computer, launch a web browser.
- Enter the AP’s IP address.
- The login box will display; enter admin and your password to log in.
- To access the User Accounts options, select Management > Configuration > System > Advanced.
- On the PC, you can switch user accounts by going to the next screen.
- Locate the Password section and enter the updated password.
- In the Confirm Password field, type the password again.
NOTE : If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is mywifiext.net setup
How to Update Netgear WAX615 Firmware?
Updating the firmware of the WAX615 access point will improve its performance and offer new features. The following are the steps you should follow in order to upgrade the AP’s firmware:
- Open a web browser on a PC that is linked to the AP’s WiFi, just like you would to visit the extender’s portal by connecting to the Netgear_EXT network.
- To gain access to the AP, use the new password.
- From the Dashboard, choose the “Check for Upgrade” button.
- Upgrade Currently, if the latest version is accessible.
- Follow the directions displayed in the dialog boxes to install the latest firmware version.
How to Reset Netgear WAX615?
Resetting the device will fix a variety of AP-related issues. Use these procedures to successfully reset the WiFi access point that Netgear brought in:
- Verify that the AP is connected to a reliable power supply.
- On the bottom panel of the access point, look for the Reset button that is recessed.
- Now use a straightened pin to push and hold the Reset button.
- Pressing this button takes ten seconds.
- When the button is released, the factory reset will be complete.
- After the process, which should take two minutes, the AP will ultimately reboot.
